Difference between revisions of "EShapeoko 1.3 Assembly: Z motor"

From Amber Spyglass Ltd
Jump to: navigation, search
(Created page with "== Go To == * Next step: Z rail * Previous step: Z leadscrew * Back to EShapeoko 1.3 Assembly Inst...")
 
Line 1: Line 1:
 +
'''''Preliminary instructions'''''
 +
 +
You need all the parts from Pack 9, and the motor plate assembly from the previous step.
 +
 +
Put the flexible coupler on the motor shaft, but do not tighten it yet.
 +
 +
== NEMA 17 ==
 +
 +
Use the three long M3 screws to attach the motor to the Z motor plate, on the same side
 +
as the bearing. Use one longer and one shorter spacer on each screw. Use the three
 +
holes at the corners of the plate; do not use the hole near the larger oval holes.
 +
 +
== NEMA 23 ==
 +
 +
Put a washer on each screw. Insert them through the three holes in the corners of the
 +
plate, from the side opposite the bearing. Put one longer and one shorter spacer on
 +
each screw. Offer the motor. Put a washer and a nut on each screw. Tighten, holding
 +
the nuts with an open-ended 8 mm spanner.
 +
 
== Go To ==
 
== Go To ==
 
* Next step: [[EShapeoko 1.3 Assembly: Z rail|Z rail]]
 
* Next step: [[EShapeoko 1.3 Assembly: Z rail|Z rail]]
 
* Previous step: [[EShapeoko 1.3 Assembly: Z leadscrew|Z leadscrew]]
 
* Previous step: [[EShapeoko 1.3 Assembly: Z leadscrew|Z leadscrew]]
 
* Back to [[EShapeoko 1.3 Assembly Instructions|assembly top page]]
 
* Back to [[EShapeoko 1.3 Assembly Instructions|assembly top page]]

Revision as of 14:40, 28 January 2016

Preliminary instructions

You need all the parts from Pack 9, and the motor plate assembly from the previous step.

Put the flexible coupler on the motor shaft, but do not tighten it yet.

NEMA 17

Use the three long M3 screws to attach the motor to the Z motor plate, on the same side as the bearing. Use one longer and one shorter spacer on each screw. Use the three holes at the corners of the plate; do not use the hole near the larger oval holes.

NEMA 23

Put a washer on each screw. Insert them through the three holes in the corners of the plate, from the side opposite the bearing. Put one longer and one shorter spacer on each screw. Offer the motor. Put a washer and a nut on each screw. Tighten, holding the nuts with an open-ended 8 mm spanner.

Go To