Difference between revisions of "EShapeoko 1.4 Assembly: V-wheels"
Jump to navigation
Jump to search
(Created page with "The parts for this step are in Packs 1 and 2. Make sure you use the precision washers (EM-W5Pa) from Pack 1, not ordinary washers from other packs. {{Dual-bearing V-wheel Ass...") |
|||
| Line 1: | Line 1: | ||
| − | The parts for this step are in Packs 1 and 2. Make sure you use the precision washers ( | + | The parts for this step are in Packs 1 and 2. Make sure you use the precision washers (W5Pa) from Pack 1, not ordinary washers from other packs. |
{{Dual-bearing V-wheel Assembly}} | {{Dual-bearing V-wheel Assembly}} | ||
Revision as of 00:26, 10 September 2016
The parts for this step are in Packs 1 and 2. Make sure you use the precision washers (W5Pa) from Pack 1, not ordinary washers from other packs.
| Item | Part Number | Part Description | Count |
|---|---|---|---|
| For each wheel | |||
| 1 | MW1 | V-wheel sleeve | 1 |
| 2 | G5 | 5 × 16 × 5 mm bearing | 2 |
| 3 | W5Pa | 5 mm precision washer | 1 |
Lay one bearing on a flat surface. Push a V-wheel sleeve over it. The parts are designed to force-fit, so push firmly straight down. Thread this on a long M5 bolt, bearing side first, followed by a precision washer and the second bearing. Place the second bearing on a flat surface, and push the V-wheel sleeve over it too. Make sure both bearings are in as far as they will go. Remove the bolt.
If the V-wheel does not rotate smoothly, see Troubleshooting.
Repeat 20 times.
Go To
- Next step: smooth idler wheels
- Previous step: prep work
- Back to assembly top page