EShapeoko 1.2 Assembly: Smooth idler wheels
Jump to navigation
Jump to search
For this step, you need the remaining parts from Packs 1 and 2.
Item | Part Number | Part Description | Count |
---|---|---|---|
For each wheel | |||
1 | MW2 | Smooth idler wheel sleeve | 1 |
2 | G5 | 5 × 16 × 5 mm bearing | 2 |
3 | W5Pa | 5 mm precision washer | 1 |
Lay one bearing on a flat surface. Push an idler wheel sleeve over it (lip up, of course). The parts are designed to force-fit, so push firmly straight down. Thread this on a long M5 bolt, lip side first, followed by a precision washer and the second bearing. Place the second bearing on a flat surface, and push the idler wheel sleeve over it too. Make sure the bearings are all the way in, with the first bearing resting against the lip of the sleeve. Remove the bolt.
If the idler wheel does not rotate smoothly, see Troubleshooting.
Repeat six times.
Go To
- Next step: X and Y motors
- Previous step: V-wheels
- Back to assembly top page