EShapeoko 1.4 Assembly: Gantry
For this step, you need some parts from Pack 7. You also need the assembled X and Y carriages, and the the X rail.
(TO DO: instructions for alternate configurations. In the meantime, use the instructions for version 1.3.)
|Item||Part Number||Part Description||Count|
|1||S5-14||M5 14 mm cap screw||8|
|2||W5||M5 washer (form A)||8|
|3||LBA3||Belt anchor (belt behind rail)||2|
Bolt the assembled Y carriages to the X MakerSlide using four screws each. The screws holding the rear X rail also attach the belt anchors. Orient the belt anchors as shown.
This is a good time to square the Z axis. Assemble this on a flat surface and use a set square to ensure that the X carriage is vertical. Do this with the X carriage near each Y motor plate, to make sure both ends are square. Tighten the screws firmly.