EShapeoko 1.4 Assembly: Y Belts

From Amber Spyglass Ltd
Revision as of 15:52, 29 September 2016 by Admin (talk | contribs)
Jump to navigation Jump to search

For this step, you need the remaining two belt tensioners and two screws from Pack 11, and the Y belts from Pack 12. The Y belts are 250 mm longer than your Y axis. You should have tapped the lone hole of the belt tensioners.

Please follow the same instructions as for the X belt, using the end plates instead of the belt anchor plates. Install the belt tensioners at the rear of the machine, to keep them out of the way.

Warning: The belt anchors have four slots and the end plates have three. The three slots in the end plates correspond to the top three slots of the belt anchors. The bottom slot of the belt anchor plate is not used.

Go To