Difference between revisions of "Template:Dual-bearing V-wheel Assembly"
Jump to navigation
Jump to search
| Line 11: | Line 11: | ||
|- | |- | ||
|1 | |1 | ||
| − | | | + | |MW1 |
|V-wheel sleeve | |V-wheel sleeve | ||
|1 | |1 | ||
|- | |- | ||
|2 | |2 | ||
| − | | | + | |G5 |
|5 x 16 x 5mm bearing | |5 x 16 x 5mm bearing | ||
|2 | |2 | ||
|- | |- | ||
|3 | |3 | ||
| − | | | + | |W5P |
|5mm precision washer | |5mm precision washer | ||
|1 | |1 | ||
Revision as of 01:06, 10 September 2016
| Item | Part Number | Part Description | Count |
|---|---|---|---|
| For each wheel | |||
| 1 | MW1 | V-wheel sleeve | 1 |
| 2 | G5 | 5 x 16 x 5mm bearing | 2 |
| 3 | W5P | 5mm precision washer | 1 |
Lay one bearing on a flat surface. Push a V-wheel sleeve over it. The parts are designed to force-fit, so push firmly straight down. Thread this on a long M5 bolt, bearing side first, followed by a precision washer and the second bearing. Place the second bearing on a flat surface, and push the V-wheel sleeve over it too. Make sure both bearings are in as far as they will go. Remove the bolt.
If the V-wheel does not rotate smoothly, see Troubleshooting.
