Difference between revisions of "Template:Dual-bearing V-wheel Assembly"
Jump to navigation
Jump to search
m |
|||
| (3 intermediate revisions by the same user not shown) | |||
| Line 11: | Line 11: | ||
|- | |- | ||
|1 | |1 | ||
| − | | | + | |MW1 |
|V-wheel sleeve | |V-wheel sleeve | ||
|1 | |1 | ||
|- | |- | ||
|2 | |2 | ||
| − | | | + | |G5 |
| − | |5 | + | |5 × 16 × 5 mm bearing |
|2 | |2 | ||
|- | |- | ||
|3 | |3 | ||
| − | | | + | |W5Pa |
| − | | | + | |5 mm precision washer |
|1 | |1 | ||
|} | |} | ||
| Line 32: | Line 32: | ||
on a flat surface, and push the V-wheel sleeve over it too. Make | on a flat surface, and push the V-wheel sleeve over it too. Make | ||
sure both bearings are in as far as they will go. Remove the bolt. | sure both bearings are in as far as they will go. Remove the bolt. | ||
| − | |||
| − | |||
If the V-wheel does not rotate smoothly, see | If the V-wheel does not rotate smoothly, see | ||
[[V-wheel and Idler Assembly Instructions#Troubleshooting|Troubleshooting]]. | [[V-wheel and Idler Assembly Instructions#Troubleshooting|Troubleshooting]]. | ||
| + | |||
| + | [[File:EShapeOko_assembly_step_01_V-wheel_2.png]] | ||
Latest revision as of 01:14, 10 September 2016
| Item | Part Number | Part Description | Count |
|---|---|---|---|
| For each wheel | |||
| 1 | MW1 | V-wheel sleeve | 1 |
| 2 | G5 | 5 × 16 × 5 mm bearing | 2 |
| 3 | W5Pa | 5 mm precision washer | 1 |
Lay one bearing on a flat surface. Push a V-wheel sleeve over it. The parts are designed to force-fit, so push firmly straight down. Thread this on a long M5 bolt, bearing side first, followed by a precision washer and the second bearing. Place the second bearing on a flat surface, and push the V-wheel sleeve over it too. Make sure both bearings are in as far as they will go. Remove the bolt.
If the V-wheel does not rotate smoothly, see Troubleshooting.
