Difference between revisions of "Template:Dual-bearing V-wheel Assembly"
Jump to navigation
Jump to search
m |
|||
| Line 32: | Line 32: | ||
on a flat surface, and push the V-wheel sleeve over it too. Make | on a flat surface, and push the V-wheel sleeve over it too. Make | ||
sure both bearings are in as far as they will go. Remove the bolt. | sure both bearings are in as far as they will go. Remove the bolt. | ||
| − | |||
| − | |||
If the V-wheel does not rotate smoothly, see | If the V-wheel does not rotate smoothly, see | ||
[[V-wheel and Idler Assembly Instructions#Troubleshooting|Troubleshooting]]. | [[V-wheel and Idler Assembly Instructions#Troubleshooting|Troubleshooting]]. | ||
| + | |||
| + | [[File:EShapeOko_assembly_step_01_V-wheel_2.png]] | ||
Revision as of 21:24, 30 September 2013
| Item | Part Number | Part Description | Count |
|---|---|---|---|
| For each wheel | |||
| 1 | EM-MW1 | V-wheel sleeve | 1 |
| 2 | EM-G5 | 5 x 16 x 5mm bearing | 2 |
| 3 | EM-W5P | 5mm precision washer | 1 |
Lay one bearing on a flat surface. Push a V-wheel sleeve over it. The parts are designed to force-fit, so push firmly straight down. Thread this on a long M5 bolt, bearing side first, followed by a precision washer and the second bearing. Place the second bearing on a flat surface, and push the V-wheel sleeve over it too. Make sure both bearings are in as far as they will go. Remove the bolt.
If the V-wheel does not rotate smoothly, see Troubleshooting.
