EShapeoko 1.2 Assembly: X carriage

For this step, you will need the fourth motor plate, the rear X motor plate with the motor and idlers attached from two steps ago, and the remaining parts in Pack 5.

Take a deep breath...

Front plate of the X carriage

EXPLODED VIEW 2 (BACK PLATE)

PARTS TABLE

Position of V-wheels on the X carriage, as seen from the front (red: fixed X V-wheels; blue: adjustable X V-wheels; yellow: fixed Z V-wheels; purple: adjustable Z V-wheels)

INSTRUCTIONS

Part 5 (shown in orange) is EM-W5B (form B M5 washer), which is thinner (0.75 mm) than the regular washers (0.95 mm). The thinner washers are packed in a separate bag, because they are otherwise hard to tell apart (they are not painted orange in real life). It is important to get the spacing of the X V-wheels exactly right, to match the distance between the Vs of the MakerSlide, so please be careful to use the correct washers.

LINKS