EShapeoko 1.0 and 1.1 Assembly Instructions
Step 1: Assemble the V-wheels
| Item | Count | Part Number | Part Description |
|---|---|---|---|
| For each wheel | |||
| 1 | 1 | EM-MW1 | V-wheel sleeve |
| 2 | 2 | EM-G5 | 5 x 16 x 5mm bearing |
| 3 | 1 | EM-W5P | 5mm precision washer |
Lay one bearing on a flat surface. Push a V-wheel sleeve over it. The parts are designed to force-fit, so push firmly straight down. Thread this on a long M5 bolt, bearing side first, followed by a precision washer and the second bearing. Place the second bearing on a flat surface, and push the V-wheel sleeve over it too. Make sure both bearings are in as far as they will go. Remove the bolt.
Repeat 16 times (20 if you have the dual-X upgrade).
Step 2: Assemble the smooth idler wheels
| Item | Count | Part Number | Part Description |
|---|---|---|---|
| For each wheel | |||
| 1 | 1 | EM-MW2 | Smooth idler wheel sleeve |
| 2 | 2 | EM-G5 | 5 x 16 x 5mm bearing |
| 3 | 1 | EM-W5P | 5mm precision washer |
Lay one bearing on a flat surface. Push an idler wheel sleeve over it (lip up, of course). The parts are designed to force-fit, so push firmly straight down. Thread this on a long M5 bolt, lip side first, followed by a precision washer and the second bearing. Place the second bearing on a flat surface, and push the idler wheel sleeve over it too. Make sure the bearings are all the way in, with the first bearing resting against the lip of the sleeve. Remove the bolt.
Repeat 6 times.
Step 3: Mount the V-wheels on the right Y panel
