Limit and Homing Microswitch

One miniature snap-action microswitch with pin plunger. Includes mounting hardware (not pictured): two M2 × 14 mm hex socket cap screws, four M2 washers, two M2 hex nuts.

Compatible with all versions of eShapeoko, including the new aluminium motor plates.

For the Z axis of the eShapeoko, you will need a mounting solution.

Dimensions: 12.8 mm long, 5.8 mm thick, 6.5 mm tall (excluding plunger and terminals); two 2 mm diameter holes spaced at 6.5 mm, centers 5 mm below top of switch. The drawing is from a different microswitch of similar dimensions.